In this project, the robot is controlled by a cell phone that makes a call to the mobile phone attached to the robot. In the course of a call, the cell phone is assigned to automatic answer button is activated. A tone corresponding to the button pressed is heard at the other end of the call. This tone is called ?dual-tone multiple-frequency? (DTMF) tone. The robot perceives this DTMF tone with the help of the phone stacked in the robot. The received tone is processed by the AT89S52 microcontroller with the help of DTMF decoder CM8870. The decoder decodes the DTMF tone into its equivalent binary digit and this binary number is sent to the microcontroller.
???????????????????? ?????????????????????????The microcontroller is pre-programmed to take a decision for any given input and outputs its decision to motor drivers in order to drive the motors for forward or backward motion or a turn. The mobile that makes a call to the mobile phone stacked in the robot acts as a remote. So this simple robotic project does not require the construction of receiver and transmitter units.
DTMF signalling is used for telephone signalling over the line in the voice-frequency band to the call switching centre. The version of DTMF used for telephone tone dialling is known as ?Touch-Tone? DTMF assigns a specific frequency (consisting of two separate tones) to each key so that it can easily be identified by the electronic circuit. The signal generated by the DTMF encoder is a direct algebraic summation, in real time, of the amplitudes of two sine (cosine)waves of different frequencies, i.e., pressing ?5? will send a tone made by adding 1336 Hz and 770 Hz to the other end of the line. Then the command is done with the frequency assigned to it. Then the robot move according to the commands given by the user.?
?????????? ??Conventionally, wireless-controlled robots use RF circuits, which have the drawbacks of limited working range, limited frequency range and limited control. Use of a mobile phone for robotic control can overcome these limitations. It provides the advantages of robust control, working range as large as the coverage area of the service provider, no interference with other controllers and up to twelve controls.
Although the appearance and capabilities of robots vary vastly, all robots share the features of a mechanical, movable structure under some form of control. The control of robot involves three distinct phases: reception, processing and action. Generally, the preceptors are sensors mounted on the robot, processing is done by the on-board microcontroller or processor, and the task (action) is performed using motors or with some other actuators. In this project the robot is operated with the help of cell phone using the DTMF technology which is assigned in the cell phones.
Download your Full Reports for Cellphone Operated Land Rover
Advertisement